plz help me

[impulseDUDE]

so i was dry firing my ripper 2 and a screw falls out of my trigger (the top one) then my lcd screen goes blank so i turn it off...i turn it back on in semi mode and take a couple of shots with it aired up...my lcd screen gets dimmer and goes out and now it wont turn on and my membrane pad is on all the way nad i changed batteries still nothing...plz help me

[alias_killa]

might need a new membrain pad if it wont turn on with a new battrie and make sure everything is pluged into your board

[ballin]

when you changed your batteries you might have screwed the screw on the grips too far in and could have ruined it.

Otherwise, I would suspect something wrong with your LCD or board, did any moisture get in it? ALSO check for pinched wires or exposed wires that are toushing other exposed wires.

[impulseDUDE]

it works now...something was up with the battery it was weird...but it works now