m3 black dragun problem

[NORcal]

ok i got an m3 black dragun and it shoots fine for a couple shots, then just stops because the the bolt doesnt come back far enough and the trigger just clicks. if i pull the bolt back a little when this happens, it shoots a few more shots, then it stops again. the problem is not the air, its a full tank and it doesnt sputter like it has low air, i suspect i may need a longer spring?

[iamscarygrrr]

are you chopping?

edit-is your frame on tight?

[NORcal]

chopping- iunno i tested it without paint
frame on tight- yes

[PosseCapt]

try shooting it with paint. i remeber zacks spyder wouldnt shoot unless it had paint it in. If u need a new spring ill give u one at school. just like tell me if u need 1 or sum thin. oil it too

[NORcal]

well u remember how it was at that turny hecka days ago when vince used it, he had to **** it every time... i'll try tho, but i doubt it'll matter.

[Dakkon]

Try replacing the striker oring.

Also try this. Take off the barrel, and place your hand over the front hole and try shooting it. I bet it shoots fine. It's because of the backpressure.


If all else fails more pressure, so maybe turn up the reg or tighten the back (more pressure on spring) or even get a stronger spring.

[Eve_L]

Sounds like my Omen when the baterry is low. :-/ Just a thought.

[ironpanther]

oil it and then turn up your input pressure and back out the spring pressure to chrono.

[NORcal]

thanks i'll try all that