2004 Autococker Problem

[reddragon911]

hey ya'll wuts up, i just baught my new 2004 cocker a few weeks ago, WGP still ceases to impress. anyhow, my gun has been shootin really wierd..the balls curve and go all over the bloody place..my bolt is installed correctly and the paint i use is fresh what else could it be?

[evil98punk]

Paint to bore match could be an issue. Take a paintball and put it in your barrel. Then if it falls out the bore of the paint is too small for your barrel. And if it stays in your barrel try blowing it out like a blow gun. And if it can't be blown out the bore is too big and decrease accuracy. But if you can blow it out the bore is perfect. Another thing could be your paint has demples. Thats all i can think of. Let us know how that works.

[PsybusterX]

80% of that is because your paint isn't matching your barrel...

the other 20% is because you got left over paint in your barrel or bolt that is causing inconsistance airflow.

[evil98punk]

Cool I was 80% right!

[paint_punk459]

was it windy ???

[Rico]

what kinda paint are you using? some paints have an oily resedue (sp) either from the manufacturer or if it's form wal*mart some f the main may have leaked from a craked ball due to poor handleing. anyway, make sure ur paint isn't oily, dimpled or mishapen and run ur squeege throught it and see if u still have the same problem.

[PosseCapt]

if it was moving alot i dont think id be paint-barrel cuz i use a big bore and i know lots of people that use huge bore barrels and have perfect accuacey. and if the bore was too small for the paint it would break more likley than curve. Im guessing it was probly sum paint leaking or a barrel break

[brown_terror]

EYE ON MY COCKER DOES NOT REGISTER PAINT COLORS. oops too loud. eye reads between 000-001 thats it.
makes me mad

[PsybusterX]

if your eye reads 000 it means you

a) fried it
b) you pinched or ripped the eye ribbon
c) buy a new one it's dead :(

My eye is dead too, but i just got a spare in

[brown_terror]

can paint short eye?

[brown_terror]

board might be fried too, with new battery it shows flat. but gat still fires.

[brown_terror]

when i cleaned my gun there was paint under the eye cover all over the eye and the wires connected to eye. and there definitly is no pinch on the wiring

[PsybusterX]

your eye is probably dead, it shouldn't short out due to paint, because i got lit up and i got paint in my eye and all over my covers and it didn't effect it after i cleaned it.

as for the battery thing, make sure that your battery connection is good, you might have to bend one of those connectors slightly to have it catch on well, i had one that was off a bit and when i put batteries in it would say flat.

[ironpanther]

I have seen boards and eyes short from paint so it is very possible. replace your eye and clean all the paint out and see if that works.

[brown_terror]

coo thanks

[blackmagicbob]

my friends eye did the same thing it just died for no reason all you got to do it replace it and it shoots fine.

[NORCALBALLIN]

how does the paint short it out? from it chopping a ball or being shot there??

Peace, Dean
Team Loki

[ironpanther]

ussually from being shot there.