Cocker Air Problems?

[LittleC]

I have a 2K Cocker and it dry fires fine, air pressure is good but as soon as I try to put paint through it it seems to drop off drastically.

I'm not sure where to start any ideas?

[Jumper Monkey]

MAybe the IVG (internal velocity governer) is backing itself out by the vibration of the hammer going back and forth. IThat would loosen up the tension on the spring. Or a poor paint to barrel match with the ball rolling in the barrel will give different velosities when fired.

[LittleC]

Thanks, I'll check on the IVG because I know it isn't a paint to barrel match issue. I used my Freak barrel and made sure that the paint/barrel match was perfect.

Also, would the IVG go back to normal if I attempted to dry fire it after it had the issue? Because, once I take the paint out and dry fire it, it appears okay again.

Thanks for your help.

[ironpanther]

read through the autococker help thread this kind of stuff has been covered.