TOO much bounce on timmy was 2.6 help real quick

[ballin]

If I set debounce anywhere from 1 to even 22ms+ it still bounce like crazy. The microswitch activation is really early in the pull like as soo as you touch the trigger, it shoots.

K well I played most of the day with debounce 14... if you just easily pull it and try to find bounce you can't, unless you just slap the side of the trigger real quick, or walk the trigger then it goes full auto.

Would making the microswitch activation point at the end of the pull help?

Tried debounce 22 and yes it still went full auto like stated above.

so all help would be appreciated, BTW its a brand new microswitch

[I-want-an-angel]

yeah at the end of the pull should help


because what im thinking is that since it is so early in the pull the recoil of the shot is causing the trigger to vibrate causing it to keep hiting the switch and making it go full auto


maybe im wrong but thats what i was thinking

[ballin]

yeah same here, I adjusted it, just dont have air yet to try it out.

we'll see, and ill get my WAS updated to 2.8...

[DC_PAINTBALLER]

i flipped my switch to fix it and it worked a lot less bounce but there still is a little
-derek c-

[WhyAreCowsCool]

adjust that trigger!!! ;)

[NORCALBALLIN]

make the activation point mid trigger pull and not at the front! that will fix all ur problems!

[imhappy]

tooo much bounce? when is this a problem :-\

[cottonswab]

when your in the middle of a turny that cost quite a bit of money to get into