i need a program to edit my was board

[pballer1018]

i am looking for a computer program that i can use to change my board around. i already have the equlink program, so i am not looking for that. i want it so i can make my board ramp...not bounce...ramp. i know this is a very vague description but if you think you understand what i am talking about catch me on aim or post her.
thanx

[DC_PAINTBALLER]

you cant make was boards ramp i already emailed wicked air sports about it they said db1 is the fastest u can get
but if you kno sumthing i dont and you figure it out tell me
-derek c-

[WhyAreCowsCool]

well jim drew is not gunna let you know that you can alter his program for cheating purposes....

i know something you dont... ;)

[pballer1018]

o.....k....
well i asw someone at wap today making their was board ramp and doing other stuff to it.

[ironpanther]

listen to me very carefully. STOCK WAS BOARDS DO NOT RAMP. There is no way to get it to ramp because rampign is a programmed set of operations a board will perform when your each a certain BPS. There are two kinda of ramping too. Algorithm ramping where the board as a couple shots at a low bps and more as your fingers pull faster eg. 8 pulls per second 10 bps, 10 pulls persecond 14 bps etc etc. The second ramp is one off ramp. It either is on or off and the gun will jump at a certain rate of pulls and above to a set bps. Eg. 4 pulls persecond 15 bps, 10 plls person 15 bps etc. The only varience of on off ramping is if your eye logic is progammed right the gun can either jump to a preset BPS or it can just do everythign it can to max out your hopper speed like the original ramping nxl boards.
Now as far as a WAS board is concerned you need to know a coupke things, First EPROM programming, Second how to flash a non volatile memory chip with the new programming. If you can do this you might as well be making your own chips because the way the WAS boards are made you need to either use the existing version of software and figure out how to only edit the pulls versus shots rate or figure out the whole electrical layout and operation of the rest of the board before you start writing your new program.

[Dakkon]

Basically, if you could do it, you would already know.

[ironpanther]

yeah pretty much.

[pballer1018]

ok i understand wat ur saying but terry fong was at wap on sunday and he had a program on his laptop and he was changing pepoles WAS boards to different things and i just wanted to know if anyone knew a program in which i could do that. i wasnt asking if it was possible because i know it is possible s if you know a program post it.
thanx