2 problems with my impulse

[impulseDUDE]

i have 2 problems with my impulse one is i just got a tapeworm and when i put it on it wouldnt shoot when it got gassed up it would click but it wouldnt fiore and air was getting up there and then i took of the hose and it still doesnt shoot someone please help

problem 2: i just got a new trigger and i got it all set in my impulse and i adjusted so it would fire and after maybe 30 minutes of shooten it it doesnt shoot anymore the screw goes down...itz a eclipse magnetic blade trigger (i turned around the screw so i could adjust through the trigger with an allen wrench) please help

[impulseDUDE]

up some1 please help!!!!

[NorCal_Pballer]

hey try reading this

http://www.mipaintball.com/adjusting_your_blade_style_trigg.htm


it should answer your question about the trigger problems

[moballer1193]

1. try turning your pressure up and adjust ur front cap or lpr, whatever you have. turn the front screw all the way out, turn in ur tank, turn in ur front cap or lpr slowly and click the trigger every turn, that should do the trick

2. "(i turned around the screw so i could adjust through the trigger with an allen wrench)"- if you try to put the screw in with the allen part on top, you probably stripped the threads, the allen part is supposed to go down and you adjust it from the bottom. stupid q but did u leave the spring in? try shortening(sp?) your trigger pull, that might do the trick

[impulseDUDE]

does it matter if i have a hp tank?

[pbmink]

shuldent

[impulseDUDE]

ok thanks every1 for ur help i fixed my trigger problem

[Pvilleplayer]

Reset your dwells see if that helps the firing problem. turn the gun to 180 PSI and turn the dwells all the way down (check manual for more help) then increase the dwell 1 beep, pull the trigger 2-3 times, check velocity, raise/lower acordingly.

[ballin]

It is probably improper installation of the tapeworm...

it requires some modifying